🤖Robot Design Search

this is a robot hand i made in tinkercad paperclips or small nails requiredstill a work in progress it may need some tweaking from printer to printerthe hand is made to work with strings tied on a servo powered by an arduino or raspberry pi/pi picomaterialsrubber bandsstring yarn fishing lineglue or tapemicrocontroller5 servospaper clips*means you do not need these if you do not want it to be automated instructionssand 3d printed parts until smoothput them together like the way it was printedthen cut paper clips to fit in the holes and make them stay in holescut 5 lengths of stringput them through the holes and under the fingertip and glue/tape it theretake a stretched rubber band and glue/tape it to each finger and then hand so it stays downtest hand by pulling a string and it should open the finger then let go and the finger should return to its place.